ecappliance
4.7 · 116 Google reviewsOven & Range Repair in Charlotte, NC
An oven that runs 50 degrees cool ruins everything you bake in it. We calibrate, test under load, and replace only the part that is actually at fault.
- INSURED Fully insured for your protection
- 90-DAY WARRANTY Parts & labor guaranteed
- SAME-DAY SERVICE Most repairs done the day you call
Book by 12 PM and we aim to be there the same day.
Wall oven and freestanding range repair
Oven faults divide neatly into three groups: it does not heat, it heats to the wrong temperature, or the controls do not respond. Each group has a short and well-understood list of causes — an element or igniter, a temperature sensor out of tolerance, or a control board and its touch panel.
We repair wall ovens, freestanding and slide-in ranges, double ovens, and gas and electric models alike, including convection fans and self-clean circuits. Temperature is verified with a calibrated probe under real load rather than trusting the panel reading, since a display that says 350°F is exactly what a failed sensor produces.
What usually goes wrong
The faults we see most often on oven & ranges. If yours is on this list, say so when you book — it helps us load the right part before we set off.
-
Oven will not heat at all
A broken bake element, a failed igniter on a gas oven, or a relay on the control board that no longer closes.
-
Bakes unevenly, or well below the set point
A temperature sensor drifted out of tolerance, a weak element, or a convection fan that has stopped.
-
Gas burners click but will not light
A dirty or cracked spark electrode, a wet burner cap, or a failed spark module.
-
Broil works, bake does not (or the reverse)
One of the two elements has failed open, or its relay on the control board has.
-
Display dead or unresponsive to touch
Touch panel membrane failure or a control board fault — these are diagnosed separately as the parts differ greatly in price.
-
Door will not close flush, or heat escapes
Worn door seal, dropped hinges, or a warped inner panel letting the cavity lose temperature.
Not sure which of these it is? That is what the diagnostic visit is for — tell us the symptom and we will identify it on site.
WE REPAIR ALL MAJOR BRANDS
Factory-independent service for the major household appliance brands Charlotte homeowners rely on every day.
Why Charlotte Homeowners Choose Us
Upfront pricing, experienced technicians, and every repair backed by a 90-day parts & labor warranty.
-
Experienced Technicians
Skilled, background-checked, and focused on getting it right the first time.
-
Parts On The Truck
We stock the parts that fail most often, so more repairs finish in one visit.
-
Upfront Pricing
You hear the full price and approve it before any work starts.
-
90-Day Warranty
Parts and labor are covered for 90 days. If it comes back, so do we.
-
Same-Day Appointments
Call in the morning and, in most cases, the repair happens the same day.
-
Local & Reliable
Based in Charlotte and serving the neighborhoods around it, not a call center.
Oven & Range Repair prices
Charlotte, NC
-
Diagnostic visit Applied toward the repair once you approve the work.from 59.99
-
Bake or broil element Includes calibrated temperature verification.from 149
-
Oven temperature sensor Includes recalibration after fitting.from 139
-
Gas igniter or spark module Gas-certified work, tested under load.from 189
-
Door seal and hinge adjustment Restores cavity seal and closing alignment.from 139
-
Control board or touch panel Quoted after the fault is isolated to one part.from 229
Starting prices for the most common repairs, including parts and labor. The exact price for your appliance is confirmed on site after diagnosis, before any work begins — and every completed repair carries a 90-day parts and labor warranty.
Get a firm price for your repairCustomer Feedback
What Charlotte Homeowners Say
My oven says 350 but bakes like 300. Is that repairable?
Yes, and it is one of the most common calls. It is nearly always the temperature sensor, and it is a short repair with a calibrated verification afterwards.
Do you work on gas ranges as well as electric?
Yes — igniters, spark modules, safety valves, and burner assemblies on gas, and elements, sensors, and control boards on electric.
Is a self-clean cycle bad for the oven?
It is hard on door seals, sensors, and control boards because of the very high temperature. If an oven fails right after a self-clean, that is usually why, and the failed part is normally the thermal fuse or the control.
Can you repair a double wall oven?
Yes. Each cavity has its own elements and sensor, so a fault in one does not mean the whole unit needs replacing.
Our Repair Services
Professional repair for all major residential appliance brands and models in Charlotte, NC.
-
Refrigerator Repair
Cooling issues, compressor failures, leaking water, ice maker problems, and erratic temperature control. Learn more about this repair -
Freezer Repair
Frost build-up, temperature drift, failed defrost cycles, door seal problems, and chest freezer faults. Learn more about this repair -
Ice Maker Repair
No ice, hollow or small cubes, jammed harvest cycles, leaking fill valves, and frozen supply lines. Learn more about this repair -
Washer Repair
Vibration and loud noises, spin cycle errors, failure to drain or fill, and door gasket replacements. Learn more about this repair -
Dryer Repair
No heat or weak drying, drum not rotating, thermal fuse blowing, squeaking rollers, and vent inspection. Learn more about this repair -
Dishwasher Repair
Drain pump blockage, spray arm malfunctions, water leakage, incomplete cycles, and latch failures. Learn more about this repair -
Oven & Range Repair
Ignition failures, broken bake and broil elements, inaccurate temperature, and faulty digital displays. Learn more about this repair -
Stove Repair
Cooktop burners that will not light, weak flames, dead induction zones, and cracked or unresponsive controls. Learn more about this repair -
Microwave Repair
Magnetron replacements, turntable drive failure, buzzing noise, faulty touch panels, and door switches. Learn more about this repair -
Garbage Disposal Repair
Jammed impellers, humming without turning, leaks at the flange or drain, and units that will not switch on. Learn more about this repair
Service Areas Across the Charlotte Metro
Serving homeowners throughout Mecklenburg County and the surrounding Piedmont region.
We provide appliance repair across Charlotte and the surrounding area, including the neighborhoods and towns below.
Charlotte Neighborhoods
Surrounding Towns
Don’t see your area listed? Call 980-880-7788 — we may still be able to help.
Request service